![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
The weather is getting cold and I have to buy water heaters at the peak. I will summarize the experience of many years of using gas water heaters for your reference.
My kitchen gas pipeline (liquefied petroleum gas) outlet is 8 meters away from the toilet. 7 years ago, if the hot water pipe was taken into consideration, the distance was too far away. The loss of hot water in the middle and the waste of early cold water and late hot water would not be counted. , decided not to lay water pipes. Because the hot water is only used for washing vegetables and washing dishes, the kitchen has not been used for a long time. The area has 9 square meters, and it has bought a 280 meters straight-lined 5 litre water heater (not sure to follow). Dr. 8 liters of gas water heaters in the washroom are used alone to store gas. I live on the fifth floor and the water pressure is acceptable. However, I discovered that 8 litre water heaters often fail to catch fire due to insufficient water pressure. Afterwards, I personally advocated the modification of the pipeline and removed the water heater. Inlet connection hoses and valves, with 6 points aluminum plastic pipe directly connected, the effect is surprisingly good, all 0K!
As time went by, I noticed that the altar installed gas was rising, sometimes the bath was half-hearted, and then it was very inconvenient to change the air (my family bathed in a bath). So I took (stolen) an oxygen hose from the kitchen to the factory. The corner line led to the bathroom, although the effect of the housing is good, so it has been used normally until the end of last year. However, in August of last year, due to pipeline changes in natural gas, suddenly found that the water in the winter bathing is not hot, so personal subjectively think that due to the water heater is not in place caused by the conversion, in October 30 this year, Wuchang Division entrance Suning opened, through the jars After learning, I decided to buy a Linus RUS-10FE2C gas water heater with a price of 1550 meters, another restaurant roll of 60 meters (not used for obsolescence), a 100-meter shopping roll (not used for obsolescence), and a shopping volume of 150 meters (plus 49 Mimi bought a MP3), a velvet blanket, a bath towel, and two boxes of 200 suction paper towels.
On the 31st, Lin came to install, after the installation of pressure measurement, air pressure less than 400, according to the required minimum pressure to 1800 to normal use, analysis of the reasons, the original is not my water heater problems, is the connection of the pipeline is too long, caliber Too small, caused by too much tube consumption, the original liquefied gas pressure of 2800 available, the natural gas pressure is only 2,000 small, so the winter water is not hot. The solution was to install the division's self-contained gas-operated aluminum-plastic 6-in charge to replace all of my original pipes. The guy used a pipe 20 meters, 1 meter 14 yuan x 20 = 280 meters, and then processed the money 20 meters connected joint, Elbow, valve and other common use to go 360 meters. However, the effect was surprisingly good. After the pressure test, the natural gas pressure at the outlet of the water heater exceeded 2100 (the water heater in the forest had a special pressure measuring port).
Finally, I added that the input power of my water heater is 70W, which is higher than that of other water heaters. It is because the fan installed in the lower part of the burner plays a dual role in assisting combustion and exhausting the air, and some water heaters have low input power. This is because its fan is mounted on the upper part of the burner is only a fan.
Home improvement tricks Haier water heater gas heater
Cabinet Locks Co., Ltd. , http://www.nspadlocks.com