Railway protection net

Flat iron fence protection net

Appearance size 1960×2790mm Frame: square tube 60×40×2.5mm, left and right square tube 40×40×2.5mm, 40×3 flat steel welded in the middle, four reinforcing ribs are 40×4 flat steel, the length is 1000 and 1200mm.

The surface of the mesh is dip-coated (green), requiring a thickness of 0.8-1.2 mm, uniform coating, uniform color, smooth surface, no sag, dripping, powder bubbles, cracks and other defects. Upper solder joints, two points on the left and right, one point behind, the length of the weld is 10-15mm; the lower joint is two points on the left and right, the middle point, the length of the weld is 10-15mm. The welding between the rib and the square tube is full, and the welding requirements are firm. After welding, the welding slag is removed and the welding joint is smooth. After welding, the mesh warp is not more than 8mm.

Angle steel fence protection net

1. Appearance size is 1750×2750mm 2. The frame is made of angle steel of 40×25×3.0mm. 3. The mesh is welded by steel wire with diameter of 4.0mm or 3.5mm. 4. Mesh hole 75×150 or 50×100mm 5. The connecting piece is made of 40×55×8.0mm iron plate. 6. The metal mesh should be treated with anti-corrosion and plasticizing after galvanizing. 7. When the isolation fence is set in the undulating terrain, the ground can be rebuilt into a certain longitudinal slope. It is also possible to adjust the height of the column and the position of the connecting piece by setting the parallelogram of the metal mesh to a certain angle, and the isolation fence is stepped.

Rectangular tube fence protection net

1. Appearance size is 1700×3000mm (center distance of column) 2. The frame is made of 30×50×2.0mmd rectangular tube. 3. The mesh has a wire with a diameter of 4.0mm welded. 4. Mesh 75×150mm

5. The column adopts 40×40×2.5mm square control to set up the column, the mesh link plate adopts 90 degree angle and the thickness is 4.0mm steel plate. 6. The metal mesh should be galvanized and anti-corrosion plastic treatment. 7. Protective fence installation To achieve "strict, straight, homogeneous, beautiful", the line is closed tightly, leaving no gaps; straight along the line, not too far and near; the vertical transition of the top and bottom of the protective fence is smooth and tidy, not high or low; The overall effect is beautiful, avoiding a messy feeling. The site should be leveled before installation, and the bottom of the fence should be designed to be 10 cm from the ground. If it is not met, it should be backfilled.

Lockout Kit

Individual Safety Kit,Safety Kit,Safety Kit Wholesale

Lockout Station And Lockout Kit Padlock Co.,Ltd , http://www.chpadlock.com