![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
How to draw the floor tile to illustrate , how do you want to know how to make the floor tile? There is a step in the floor tile is to pull the wire, in the four corners at the same time with pressure, make it in parallel with the mortar, and pull the cable 2-3 cm higher, and then Tap with a wooden or rubber hammer, and level your face with a level ruler. Then let's take a look at how to figure out how to lay a floor tile . Want to understand can see Oh!
How to lay the floor tile
Tile soaking
First need to clean the tiles, soak in more than 2 hours, why do you want to soak it? Soaking is because the tiles fully absorb enough water, so you can avoid absorbing moisture in the material after laying, resulting in insufficient moisture adhesive , Affecting the fastness of adhesion, causing emptying and falling off. The tiles need to be removed from the water and wiped off the surface moisture before the tiles are fully immersed and before the tiles are laid for paving.
2. Set the auxiliary line
Pulling is a very important step when sticking floor tiles. It is necessary to suspend the vertical line on the wall leveling layer to determine the size line of the tile. Then set the horizontal line, so that you can ensure that the tile is laid horizontally and vertically and the surface is flat.
3. Set the support board
Tiles require a horizontal line to confirm the level, and a board that supports the tile is provided to prevent the tile from displacing or falling before reaching the adhesion strength.
4. Lay out in order
Tiles are generally laid out by the edge of the door (or balcony), from top to bottom, from left to right. The specific paving method is: first leveling the layer with water, using a shovel to put the mortar (or other adhesive) on the back of the tile, and then paste the tile on the wall, then tap the tile with a shovel handle or rubber hammer, Fill the space between the walls and the tiles with the mortar.
5. Cleaning and maintenance
After the floor tile is finished, the stains and dust on the surface need to be cleaned in time. The surface contamination is serious, especially when it is contaminated with some difficult-to-remove stains, it can be wiped with 10% diluted hydrochloric acid solution. If you use dilute hydrochloric acid, you must finally rinse it with tap water.
It should be noted that the mud slurry and other debris in the brick joints should be promptly cleaned when the floor tile is attached, and the stains should be wiped off with a damp cloth. If you wait until the slurry is hard and then clean up, it will not only take time and effort, but will have poor results, and it may even cause permanent damage to the glazed tiles.
The above is how to draw the floor tile for everyone to bring the diagram and step instructions, after reading the floor tile will not be ignorant, when the floor tile paving there are still many places that need attention, hope Can help everyone, if you want to know more information, please continue to pay attention to this site.
Flooring
Marble Pattern Steel Coil is a pattern design Prepainted Steel Coil, it has the natural texture of stone and strength of steel, it brings more choices to the designers. it is environmental friendly, has long service life and free of maintenance. The base metal could be galvanized steel, galvalume steel, stainless steel. Paint coating could be PE, HDP, FEVE, PVDF, we cooperate with famous brand of PPG, Beckers, Akzo Nobel, etc. We offer 20 years warranty for PVDF coating.
Marble Pattern Steel Coil
Marble Pattern Steel Coil,Colored Steel Sheet Coil,Marble Metal Sheet,Marble Color Coated Steel
Shandong Wofeng New Material Co., Ltd. , https://www.wofengcoil.com